1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-94
Basic Settings
Clicking the BASIC SETTINGS tab brings up the LA BASIC SETTINGS page (Figure 5-76),
which displays the various parameters for LA basic settings. The parameters for this
page are shown in Table 5-59.
Figure 5-76. LA Basic Settings Page
Table 5-59. LA Basic Settings Page Parameters
Parameter Description
LA Status This is used to enable or disable LA in the switch.
System Priority
This parameter specifies the priority value associated with the Actor's system ID.
The allowed value ranges from 0 to 65535. The default value is 32768.
System ID
This parameter specifies the Bridge MAC Address that is displayed. This is a
read-only parameter.
Zero Partner Key This is used to choose the partner key as Allowed or Not Allowed.
To Next Page
Loading...
