5-95
Chapter 5: Web Based Management Utility
Interface Settings
Clicking the INTERFACE SETTINGS tab brings up the PORT CHANNEL INTERFACE BASIC
S
ETTINGS page (Figure 5-77), which allows you to configure port channels. The
parameters for this page are shown in Table 5-60.
Figure 5-77. Port Channel Interface Basic Settings Page
Table 5-60. Port Channel Interface Basic Settings Page Parameters
Parameter Description
Port Channel ID
This parameter specifies the identifier of the port channel interface. The valid
values are between 1 to 65535.
Port List Displays the port list.
No of Ports Displays the number of ports configured in LA.
Admin State Displays administratively: port channel Up or Down.
Oper State Displays operational status for port, Up or Down.
MTU
This parameter specifies the MTU value for this port channel. The allowed
values range from 1500 to 9216. The default value is 1500.
Switch port mode
This parameter specifies the switch port mode for the port channel: Access,
Trunk or Hybrid
Load balancing
User can either choose Source MAC Address Based, Destination MAC Address
Based, Source and Destination MAC Address Based, Source IP Address Based,
Destination IP Address Based, or Source and Destination IP Address Based.
Description This parameter specifies the interface description string for this port channel.
To Next Page
Loading...
