1/10 and 10-Gigabit Layer 2/3 Ethernet Switches
3-4
Booting using a Fallback Firmware Image
Use the procedure below to boot using a fallback firmware image.
1. Reboot the switch by power cycling the switch power.
2. During reboot, press any key when it displays the below text (as shown in
Figure 3-1).
Hit any key to stop autoboot: 5
3. Once the boot sequence is interrupted, it will display menu options as shown in
Figure 3-1.
Figure 3-1. Displayed Text for Rebooting
To Next Page
Loading...
