3-5
Chapter 3: Installation and Setup
Use the "H" option to set hardware information by typing the character H. This will
display the hardware information that can be changed as shown in Figure 3-2.
4. To choose the boot from a fallback image, type the command: rflag=1
5. Type Save to save the hardware information.
6. Type Exit to exit the hardware information menu.
7. Type J to boot the image. In this case it will boot from a fall back image.
8. In case you wish to later move back to a normal image, repeat the above the steps
with one difference for step 4, where you should use the command rflag=0
instead of rflag=1 to boot with a normal firmware image.
Upgrading Fallback Firmware using TFTP
To upgrade the fallback firmware using TFTP, use the procedure below:
1. Copy the latest firmware to the TFTP root directory on the TFTP server machine.
2. Make sure the upgraded TFTP server and switch both have network reach ability.
Figure 3-2. Setting Hardware Information
To Next Page
Loading...
