Note: In the Simple interface mode, the Logger Step parameter is hidden, but the instrument
will use settings previously defined in the Advanced mode or default settings (1s).
Logger file name
The Logger Name position enables defining the logger
file name, which consists of a prefix and a number. The
default logger file prefix is L. The name can be of up to
eight characters long. After pressing the ◄ / ► key, the
text editor screen is opened.
The edited name is accepted and saved after pressing
the <Enter> key. The special warning is displayed in
case the file with the same name already exists in the
memory. The instrument informs with the message
“Incorrect File Name” and waits for the <Enter> key to
be pressed.
If the name is new the instrument changes the
Logger Name in the Logger Setup list.
Logging Summary Results
The Summary Results parameter switches on or off
logging the full set of Summary results that the
instrument measures with the Integration Period step:
L, Leq, LE, Lden, LEPd, Ltm3, Ltm5, Ln, OVL, Lpeak,
Lmax, Lmin, EX, SD.
Note: In the Simple interface mode, the Summary Results parameter is hidden, but the
instrument will use settings previously defined in the Advanced mode or default settings (On).
4.5.2 Selecting results for logging – Logger Results
In the Logger Results list, you can select results for
three independent profiles, which will be logged in a
logger file with the Logger Step.
The list of logger results depends on the measurement
function. For the Level Meter function, it is possible to
log next results: Lpeak (Lpk), Lmax, Lmin, Leq, LR1
and LR2.
Activation / deactivation can be done with the ◄ / ► key
pressed with <Shift>. The position is changed with the
◄ / ► or ▲ / ▼ keys.
Note: When Logger is switched Off or no results for logging were selected, the logger plot
cannot be activated in Disp. Modes and therefore doesn’t appear on the display.
Note: In the Simple interface mode, the Logger Results position is hidden, but the instrument
will use settings previously defined in the Advanced mode or default settings (all results are
selected).
To Next Page
Loading...
