8.3 VOICE COMMENTS – COMMENTS
The Comments position enables
defining the file name for the
voice comments recording. This
position is available only in the
Advanced interface mode. You
can record voice comments in all
interface modes.
To record a comment, press simultaneously the ◄ / ►
key when a measurement is stopped. This will bring up
a screen with a question to which logger file to link the
file containing a comment - to the previous (Prev.) or the
next one (Next). After selecting an answer and pressing
the <Enter> key, the record command screen will open.
After starting the recording (Start rec.) with the <Enter>
key, red circle that indicates “recording in progress” will
start to flash at the top line of the screen. In this case,
you can comment the measurement. Press <Enter> to
finish recording. The recording end will be confirmed
with the message "Saved O.K.".
The file with voice comment will be saved in the same working directory as a
logger connected file with a name starting with @ and icon .
8.4 DISPLAYING LEQ & LAV RESULTS – LEQ & LAV
The Leq & Lav position enables setting the mode of displaying the Leq and Lav
results.
This position is available only in the Dosimeter function and in the case of the
Advanced interface mode. See the description of this function in Chapter 11.7.1.
8.5 ACTIVATING WARNINGS – WARNINGS
The Warnings position allows to activate messages,
which will be displayed during the normal operation of
the instrument.
If Logging is active, the instrument will generate a warning if you start a
measurement without logging results to a file (i.e. when Logger is disabled).
To Next Page
Loading...
