14.3.1 Instruments’ status screen
In the scanning/status screen you may observe the state of a set of instruments.
Each instrument status is displayed in the frame that contain up to tree fields. First field displays the
instrument name and serial number. Second field shows the instrument status (Turned off) or if it is
turned on – the measurement status. If the measurement is stopped the field is red, if in progress it is
green, if in pause – yellow.
The third field contains several icons that inform you about:
Internal battery status of the selected instrument. Battery capacity is displayed as
a percentage. When the battery is low, the icon turns red.
Internal memory status of the selected instrument. The green area and the
percentage display the empty memory capacity.
Dose alarm. If the dose exceeds the threshold level, the icon is red, and the mobile
device vibrates.
Movement of a controlled person. If the controlled person is moving, the icon is
green, otherwise the icon is red (not used in SV971A instruments).
Someone is using the instrument’s keyboard (not used in SV971A instruments).
Lockout status due to different current device control over this instrument.
As an example:
- The instrument SV 100A #44897 is switched off.
- The instrument SV 100A #44897 is switched on and
measurement is stopped. Battery charging is 95%, free
memory is 99%, no alarm, the controlled person in not
driving a vehicle.
- The instrument SV 104A #56400 is switched on and
measurement is running. Current Dose value is
displayed. The controlled person presses the
instrument’s button and this instrument is already
controlled by another mobile device. Note, that since
scanning there may be a few seconds’ delay.
To Next Page
Loading...
