7.7 SELF-VIBRATION MARKER – SELF VIBRATION
The Self Vibr. position enables defining the threshold
for self-vibration of the instrument for marker
registration. The special marker will be written to the file
when self-vibration of the instrument is higher than
defined in the Marker Thr. position.
This position is available only in the Advanced user
interface mode.
7.8 PROGRAMMING INTERNAL REAL TIME CLOCK – RTC
The RTC position enables programming the internal
Real Time Clock of the instrument. This clock is
displayed in the top right corner of the display.
To set year, month, day, hour, minute or second, select
the appropriate field with the â—„ / â–º or â–² / â–¼ key, select
value with the â–² / â–¼ key pressed with <Shift> and
press <Enter> or <ESC> to exit this screen.
7.9 CHECKING INSTRUMENT PROPERTIES – UNIT LABEL
The Unit Label position enables checking the model of
the instrument, it’s serial number, the current software
version installed and the appropriate standards, which
the instrument fulfils.
Note: The contents of the Unit Label should be always sent to the Svantek service department
or official representative in case of any problems faced by the user during the instrument’s
normal operation.
To Next Page
Loading...
Need help?
General
