Svantek SV 971A - 5 Configuring Data Viewing - Display; 5.1 Enabling Views - Display Modes

SV 971A User Manual
48
5 CONFIGURING DATA VIEWING – Display
The Display section contains elements for programming
measurement result views and display parameters.
The content of the Display list depends on the selected
measurement function.
To open the Display section, press the <Menu> key,
select the Display position and press <Enter>.
<ENT>
The Display section contains following items:
Disp. Modes allowing you to enable modes of the measurement results presentation (views);
Disp. Scale allowing you to adjust the Logger and Spectrum views;
Spect. View allowing you to select spectra to be viewed. This position becomes available only in
the 1/1- and 1/3-octave analysis functions;
Meas. Res. allowing you to select measurement results to be displayed;
Logger Res. allowing you to select time history results to be viewed as a plot;
Screen Set. allowing you to switch rotation of the screen on/off and set the energy saver function.
5.1 ENABLING VIEWS – DISPLAY MODES
The One Result view is always enabled. Other views can
be enabled or disabled in the Display Modes screen.
You may switch in the measurement mode between
those views, that were enabled in the Disp. Modes
screen.
<ENT>
In the Level Meter function, following views are available: 3 Profiles, Statistics,
Logger, Running SPL and File Info.
In the analyser functions, additional view (Spectrum) becomes available.
Changing views
The view can be changed with the ▲ / ▼ key pressed
with <Shift> or with the <ESC> key.
<Sh>/▲
5.1.1 One Result view
In the One Result view, any
measurement result, selected in
the Disp. Res list, may be viewed.
The One Result view may have
different sub-views. You may
change the sub-view of the One
Result view by pressing <Enter>.
<ENT> <ENT>