SYSMEX CyFlow Cube 8 - Page 147

12 Software description
CyFlow
®
Cube 8 | Operating Manual | May 2018 | Revision 032 147
The Worklist buttons are:
 New: Click the button to create a new Worklist or a new Playlist.
 Open: Click the button to open an existing Worklist or Playlist.
 Save: Click the button to save the current Worklist with the same name.
 Save As: Click the button to save the current Worklist with a new name.
 Select Columns: Click the button to open a dialogue to customise the
Worklist:
To display or hide the columns in the Worklist, select or deselect the
check boxes next to the columns. Some check boxes are disabled, the
corresponding columns are always displayed.
Columns can be reordered by dragging and dropping except for the first
three columns.
The "Lab #" and "Sample ID" columns can be renamed by
double-clicking on the name and entering a new name of up to 30
characters. A "locked" icon on the right of a column name indicates that
the name cannot be changed.
For a description of the columns (see chapter Worklist rows and
columns on page 147).
To get back to the default settings, click the Defaults button in the
dialogue.
 Previous Sample: Click the button to activate the previous sample in the
Worklist.
 Next Sample: Click the button to activate the next sample in the
Worklist.
 First Sample: Click the button to activate the first sample in the Worklist.
 Last Sample: Click the button to activate the last sample in the Worklist.
 Expand/Restore: The button is disabled if the Worklist is undocked.
Clicking the Expand button sets the Worklist pane to the expanded
position which fills the current Workspace area. The button changes its
name to Restore. Clicking the Restore button resets the Worklist pane
to the previous docked position.
Worklist rows and columns
Each row of the Worklist is a Worklist item and represents one prepared test
from a given sample.
In the columns, the definitions for acquisition can be edited. The columns
displayed in the Worklist can be customised using the Select Columns
button.
If the column width does not allow the contents of a cell to be displayed in
full, the text will be truncated and ellipses ("…") will be displayed at the end
of the text. When hovering over this, the full name will show as a tooltip.