SYSMEX CyFlow Cube 8 - Page 150

12 Software description
150 CyFlow
®
Cube 8 | Operating Manual | May 2018 | Revision 032
 Stop Value: If a deviating stop condition is set in the "Stop Conditions"
column, the stop value can be entered here.
 LMD File Name: This column displays the LMD file name and path
created at the successful termination of acquisition. The column is
automatically filled and cannot be changed. The file name consists of the
run number, the timestamp at the end of data acquisition and the sample
ID.
Activating Worklist items
To activate a Worklist item, double-click on the item. The Worklist item is
then marked by a green arrow in the "Active" column in the Worklist. Settings
and results associated with the active Worklist item are displayed in the
Workspace area. If no Workspace file was associated with the Worklist item,
a default Workspace file is created.
Only one Worklist item can be active at a time.
When acquisition is in progress, the acquired Worklist item is active.
Activating another Worklist item is not available.
Selecting Worklist items
To edit Worklist items, they need not to be activated but must be selected.
Selected Worklist items are highlighted in blue.
The following options for selecting Worklist items are available:
 Single click on a Worklist item to select it.
 To select consecutive items, drag the mouse cursor over the Worklist
rows.
 To select multiple items, hold down the Ctrl key while selecting the items.
 To select all the items in the Worklist, press Ctrl + A.
 To select all items from the currently selected one to the end of the list,
press Ctrl + Shift + End.
 To select all items from the currently selected one to the beginning of the
list, press Ctrl + Shift + Home.