6 Operation
38 CyFlow
®
Cube 8 | Operating Manual | May 2018 | Revision 032
Creating a report
A report can be created manually in the Reports tab of the Workspace (see
chapter 12.8.4 Reports tab of the Workspace on page 179). Alternatively, in
Playlist mode, the Report Wizard from the Report tab of the Ribbon can be
used (see chapter 12.4.12 Report tab on page 114). When using the Report
Wizard, first select the page orientation, page size and header and footer
information (steps 1 to 4 in the following procedure).
Procedure
1. Select the Reports tab of the Workspace.
– A blank report page is displayed.
– The Ribbon switches to its Report tab.
2. From the Page Setup group on the Report tab of the Ribbon (see chapter
Pages group on page 119), select the desired page orientation (portrait
or landscape) and page size (A4 or letter).
3. From the Insert group on the Report tab of the Ribbon (see chapter
Insert group on page 120select the items to be shown in the report.
4. Click on the desired section of the report page (header, body, footer) to
insert the selected item in a default size or draw an insertion rectangle to
get a custom size.
If using the Report Wizard, select the items to be shown in the header
and footer sections of all pages of the report here before starting the
Wizard.
5. Use the options provided in the Report tab of the Ribbon to insert and
organise pages, to edit text and other items and to arrange items.
– A report is created.
6.7
To Next Page
Loading...