EXCITE + - Crossover: Technical Service guide- Ver. 4.1
Pagina 7.57
Figure 7.20-4
6. Back off the nut (e) using a 17mm wrench
and remove the two washers.
During the reassembly respect the
parts order, as detailed below: lock
down so that the spacer (1) is blocked
while the washer (2) free to move.
Mount the washer with the conical
side toward the ball-joint.
CAUTION: During the reassembly
lock down the screw (e) using a torque
wrench set for 28Nm.
Figure 7.20-5
7. Back off the screw (f) a 19mm wrench, as
shown in the figure at the side.
During the reassembly respect the
parts order, as detailed below:
CAUTION: During the reassembly
lock down the screw (f) using a torque
wrench set for 75Nm
8. Remove the lever (g) from its pin.
Continued on following page ...
To Next Page
Loading...
