Technogym EXCITE+ - Page 172

EXCITE + - Crossover: Technical Service guide- Ver. 4.1
Pagina 7.60
Figure 7.21-2
3. Block the counter-nut (b)
using a 17mm
wrench and back off the screw (c)
using a
wrench of equal size.
4. Remove the long connecting-
rod from the
lower balancer pin (d).
Figure 7.21-3
5. Back off the screw (e)
using a 17mm wrench
blocking the counter-
nut on the opposite side
using a wrench of equal size.
CAUTION: During the reassembly
lock down the screws (e) using a
torque wrench set for 44Nm.
Continued on following page ...