SYNCHRO Excite +: Service & maintenance manual - rev. 7.1
Page 9.7
9.1.16. FORMAT P&P KEY
This function formats a TGS key for Plug&Play mode operation. To select the function, when the
display shows:
FORMAT P&P
Press ENTER to confirm. At the end of the formatting procedure, hold down the CLEAR key for a
few seconds to exit. The CLEAR key can be pressed at any time to interrupt the procedure and
revert to standby mode.
9.1.17. SN
This parameter shows the serial number of the machine.
SN:xxxxx
To Next Page
Loading...
