SYNCHRO Excite +: Service & maintenance manual - rev. 7.1
Page 6.5
6.2. TROUBLESHOOTING MENU: VISIO MODEL
The procedure is activated by pressing the top right-hand corner, the bottom left-hand corner and the bottom right-
hand corner of the screen in that sequence when the equipment is in Stand-By, as shown in the figure below.
A new display will appear from which you can gain access to the various configuration menus, by
entering the password on the number keyboard:
Enter the password 2501 and press the ENTER key to confirm or EXIT to quit.
By selecting the key which is highlighted in red, you will gain access to the TROUBLESHOOTING
menu:
For the following menu, please refer to the relevant chapter in the VISIO manual.
To Next Page
Loading...
