7-47
Cn063.0 Automatic mechanical suppression enablement selection
【
6-4
】
Initial Value Unit Setting Range Effective Cn029 Reset
0 -- 0 ~ 5 -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0042H 203FH 203FH O O O O --
Setting Description:
Setting Description
0 Disable Automatic Detection of Mechanical Vibration Frequency
1
Enable Automatic Detection of First Set Mechanical Vibration
Frequency
2
Enable Automatic Detection of Second Set Mechanical Vibration
Frequency
3
Enable Automatic Detection of Third Set Mechanical Vibration
Frequency
4
Enable Automatic Detection of Fourth Set Mechanical Vibration
Frequency
5
Enable Automatic Detection of Firth Set Mechanical Vibration
Frequency
Cn064 Mechanical vibration detection level
【
6-4
】
Initial Value Unit Setting Range Effective Cn029 Reset
50 -- 1 ~ 1000 -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0043H 2040H 2040H O O O O -
Setting Description: The automatic detection level when executing Automatic Mechanical Vibration Suppression
(Cn063=1), the lower the value is, the more likely the noise is determined incorrectly, the
recommended setting is 50 or higher.
Cn065 Notch filter depth (first set)
【
6-4
】
Initial Value Unit Setting Range Effective Cn029 Reset
0 -- 0 ~ 1000 -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0044H 2041H 2041H O O O O -
Setting Description: Used to adjust the frequency depth to be suppressed, the smaller the Cn065 value is, the deeper the
frequency depth to be suppressed. Users can adjust according to actual conditions.
To Next Page
Loading...
