Topcon HiPer Lite - Page 174

Index
Topcon HiPer Lite and HiPer Lite+ Operator’s Manual
Index
P
Package contents
cables
1-8
literature 1-10
power supply/charger 1-9
RTK 1-7
software 1-9
Part number
cables
1-8
power supply/charger 1-9
PC-CDU 1-9, 2-17
configuration 2-17–2-21,
2-23–2-29
manage power 2-5–2-9
save settings 2-17
Power 2-2
board 1-13
charger 2-4
external 2-3
internal 2-2
management 2-5, 2-6–2-9
Power board file 4-24, 4-27
Power supply/charger 1-9
R
Radio configuration 2-30
software 1-9
RAM file 4-24, 4-25, 4-28, 4-29
Real-time kinematic 1-2
See also RTK 1-2
REC LED 4-3
green 4-3
orange 4-3
red 4-3, 4-4
Receiver differences 1-13
Receiver modes 4-20
See also EIM
See also Normal Mode
extended
4-8–4-9
sleep mode 4-20
zero power 4-21
Receiver setup 3-2
Recording interval 2-25
Reset key 4-3
Rover
kinematic setup 3-8–3-10
RTK setup 3-14–3-18
RS232 connection parameters 2-15
RTK 1-2, 3-10
base station setup 3-10
package contents 1-7
rover setup 3-14
RX LED 4-7
and modem antenna 5-13
blink pattern 4-7
green 4-7
no light 4-7
orange 4-7
S
Satellites in view 1-4
Security parameters 2-41
Serial number 3-6
Set baud rate
115200
2-12, 2-15, 4-24, 5-9
38400 3-14, 3-17
9600 4-4
SHMM 1-18, 1-19, 3-3, A-1
Slant height measure mark
See SHMM
Sleep mode
4-20
Software 1-9
FLoader 1-10, 4-23
Modem-TPS 1-10, 2-30
PC-CDU 1-9, 2-17–2-21,
2-23–2-29
Pinnacle 1-9
radio configuration 1-9, 2-30
Spread Spectrum 2-30
Start/stop data recording 4-3