Toro GrandStand 74534 - Page 126

ENGINE
5-1536” & 40” Toro GrandStand Service Manual
5
20. Position the pump drive belt around the engine drive
pulley, the two hydraulic pump pulleys, and the idler
pulley (Fig. 395).
A. Hydraulic pumps D. Clutch retainer
B. Idler pulley E. Pump drive belt
C. Clutch pulley F. Pump drive pulley
19. Secure the wire harness to the PTO stop bracket
using a cable tie (Fig. 394).
21. Install the extension spring from the idler bracket to
the spring anchor (Fig. 396).
Fig. 394 DSCN-2658a
Fig. 395 g. 67 G012686
Fig. 396 DSCN-2660a
22. 36” Deck: Route the deck belt around the deck
spindle pulleys. Refer to decal 119-0186 (Fig. 397).
Fig. 397 decal 119-0186
A
B
C
D
E
F