Toro Reelmaster 3100-D - Page 368

RemovingtheIdlerAssembly(continued)
6.Inspectshields,bearingandbushinginidlerassembly.Removeanddiscard
damagedorworncomponents.
InstallingtheIdlerAssembly
1.Ifshields,bearingorbushingwasremovedfromidlerarm,installnew
components.
A.Pressbushingintogroomerplateuntilthebushingiscenteredinthe
idlerarmbore.
B.Pressbearingintoidlerarmsothatbearingcontactshoulderinidlerarm
boreandinstallbearingretainingring.
C.Installbearingshieldswithockedsideofshieldtowardbearing.
D.Verifyidlerarmorientation(LHorRHcuttingunit)andinsertstubshaft
throughshieldsandbearing.Usingthroughholeinshafttopreventshaft
fromrotating,tightenangenutfrom37to45N·m(27to33ft-lb).
E.Ifcollarwasremovedfromidlerarm,installcollarandtightenfrom33
to41N·m(24to30ft-lb).
g343765
Figure213
1.Pivothub
2.Applyanti-siezelubricanttotheoutsidediameterofthepivothub(Figure
213).Positionidlerarmoverpivothub.
3.ApplyLoctitetotwo(2)socketheadscrewsandsecurepivothubandidler
armtocuttingunitsideplate.
4.Useanewcotterpinandinstallthecotterpinandclevispinsecuringthe
heightadjustmentrodtothefrontoftheidlerarm.
5.Installthegroomerreelassembly(refertoInstallingtheGroomerReel(page
9–16)).
6.Installthehydraulicreelmotortocuttingunit(refertoInstallingtheHydraulic
ReelMotor(page8–6)).
UniversalGroomer(Optional):ServiceandRepairs
Page9–14
Reelmaster
®
3100-D/3105-D
20252SLRevA