How to set up as a door phone.
The door phone can be connected to any Digital port on the system. There is an A/B jumper on the PCB to select Port
1 or Port 2. When the phone is installed, if the Call button is pushed without any programming, the user will hear an
error tone. This is because the default is to ring Hunt Group number 1 and this will have no members hence the error
tone.
To use the default hunt group create a Pilot number and assign members to the Hunt Group for Day and Night in
mode 67(01)-68(01)-69(01) or set Mode 46-st-07=d and the Door phone will ring the stations assigned in Mode 03. If
the Door phone is to unlock the door then select which relay to use in Mode 50-st-06 and wire the door mechanism to
this relay. Once the relay is set up, the internal station can press 0 while talking to the door phone to open the door.
Adjust the door phone ring time in Mode 05-11-07 to suit the customer and the Relay unlock time in Mode 05-12-04 to
allow enough time for access through the door.
How to unlock the door from the ACP using Forced Account Codes
The ACP can be used to unlock the door to allow access by staff to a building or to a secured area of the building by
using Forced Account Codes. 48 Forced Account codes can be programmed and used. When programming a FAC
remember that all 8 digits must be programmed so if a code of 12343 is needed then it is programmed 1234dddd and
then 1234 will work as a code. To unlock the door on the ACP press PRG (Left Control Key) 7, FAC, #
For details of the Access Control Feature using swipe Cards see the Access Control Help File. For details of the
Security feature see the Security feature Help File.
To Next Page
Loading...
