Program 05-18-IP : System Timing Parameters – 18
05-18-IP SYS PAR
0 0 0 0 0 0 8 5
IP = Item Pointer (01-08)
Value for each Item
IP Value Default Item Description
01 0- 0= Reserved
02 0- 0= Hotel Alarm
03 0-1 0=Disable Dial out History Feature
04 0-1 0=Bellcore/ETSI Caller ID Compatibility
05 0- 0= Reserved
06 0- 0= Play Transfer message for ECF
07 0-9 0= High Frequency Level of DTMF Generator
08 0-9 0= Low Frequency Level of DTMF Generator
01. Reserved
02. Hotel Alarm
This feature is designed for the Hotel environment but also could be used in other situations.
When the user presses an emergency button that provides a short circuit on the pair of an SLT extension line this will
trigger an Alarm Ring signal to the console with the LCD message as follow:
If a user lifts the handset to make an emergency call, but is unable to speak for some reason, after 2 minutes, the
console will receive an Alarm Ring with the LCD message as follows:
IP \ Value 0 1
05-18-02 Disable this feature Enable this feature
Note:
Extensions that need this feature should be enabled in mode: 50-STN-08: Hotel Alarm.
03. Dial Out History Feature
This parameter enables a dial out history memory buffer. When this feature is enabled the user can press [Redial] and
using the [Up/down] volume keys, scroll through the last 10 dialed out numbers and then pressing the [SPK] key to dial
out the numbers.
IP \ Value 0 1
05-18-03 Disable Enable
Extension: xx
Shower Alarm
Extension: xx
Handset Alarm
To Next Page
Loading...