Program 05-13-IP : System Timing Parameters – 13
05-13-IP SYS PAR
1 0 0 0 5 0 6 7
IP = Item Pointer (01-08)
Value for each Item
IP Value Default Item Description
01 0-1 1=Enable Intercom Hot Key Dialing
02 0-1 0=Disable Immediate SMDR output
03 0-1 0=52 Sets Caller ID Buffer Block Size
04 0-9 0= Reserved
05 0,1,5 5=Name/Num CLI Record Storing Method for LCD Phones
06 0-1 0= Disable CTI-Trunk Status Report
07 0-7 6= Saturday Least Cost Routing( LCR) – Weekly Holiday 1
08 0-7 7= Sunday Least Cost Routing(LCR) – Weekly Holiday 2
01. Intercom Hot Key Dialing
This parameter when enabled allows stations to dial a call On Hook without having to lift the handset or press the
[SPK] key.
IP \ Value 0 1
05-13-01 Disable Enable
02. Immediate SMDR Output
This parameter enables system to send out SMDR record when call is made or digit is dial out. In normal case, the
SMDR record is only available when the call is completed. This feature allows external software to know who is dialing
out with which digits or who is ringing into the system without waiting until the call is completed. The external software
can then start to count the cost from the beginning of the call. If the credit is 1 hour and time is expired, the external
software could release the connection by sending commands back to the KSU.
IP \ Value 0 1
05-13-02 Disable Enable
02. Caller ID Buffer Block Size
This parameter sets the memory block size of Caller ID buffer:
IP Value Memory Block Size Total Memory blocks
05-13-03 0 10 sets 52
05-13-03 1 20 sets 26
05-13-03 2 30 sets 17
05-13-03 3 40 sets 13
Refer to Program 83 to allocate the blocks for each DK phone.
To Next Page
Loading...