Program 05-12-IP : System Timing Parameters – 12
05-12-IP SYS PAR
0 0 0 2 7 0 0 0
IP = Item Pointer ( 01-08 )
Value for each Item
IP Value Default Item Description
01 0-1 0=Key Phone Call Transfer Method – Key Telephone
02 0- 0= Reserved
03 0-1 0=Yes Exclusive hold capability
04 0-9 2=3 Sec. Door Unlock Relay Activation Time
05 0-7 7=Enhanced Voice Mail Call Forward Protocol Type / mute digits
06 0-1 0=Linear Linear/Circular Trunk group access
07 0-9 0=Disable LED indication of Check in / Check out on DSS console
08 0- 0= Reserved
01. Call Transfer Method – Key Telephone
This parameter allows DK phone to transfer the call by normal Analog way. That is [Hold] [Station Number] [Hang up].
Normal DK phone way to transfer a call is pressing [Hold], then dial [Station Number], pressing [TRF] key.
It also adds the ability to transfer a trunk call to another trunk (External Call Transfer) using the Transfer key rather
than the Unsupervised Conference facility.
IP Value Value Description
05-12-01 0 TRF
05-12-01
1 Hang Up
05-12-01
2 Note 1
05-12-01
3 Note 2
Note:
1. DK phone can transfer a trunk to another trunk by [Hold] [DSS trunk] [TRF].
2. Use [Hold] [DSS] [Hang Up] to transfer normal call and transfer trunk-to-trunk as mentioned in Note 1 above.
02. Reserved
03. Exclusive Hold Capability
If this parameter is enabled all stations can use the Exclusive Hold Function. If the parameter is disabled no stations
will be able to place calls on Exclusive hold.
IP \ Value 0 1
05-12-03 Enabled Disabled
04. Door Relay Activation Time
The parameter sets the time that the door relay will remain activated after the Door Unlock function is activated by the
user. The Door unlock relay is set in Program 06.
To Next Page
Loading...