05. Intercom Calls to Different Station Groups
If this function is disabled then stations will not be able to make intercom calls outside their own station group (Mode
41-st-01). This parameter is for use in tenancy arrangements where each company wish's to remain totally separate
although some stations can still be allowed this function, for instance a shared Receptionist.
IP \ Value 0 1
45-stn-05 Enable Disable
06. Receive Break Alarm
If this parameter is disabled then the station will not receive the Break Alarm signal if one has been programmed in
Mode 39.
IP \ Value 0 1
45-stn-06 Enable Disable
07. Allow Unrestricted Speed Dial Access
If this parameter is disabled then the station will not be able to access any of the Speed Dial numbers which have
been unrestricted in Mode 05-05-03/04 if they conflict with the stations toll restrictions.
IP \ Value 0 1
45-stn-07 Enable Disable
08. Record Station's SMDR Data
If this parameter is disabled then calls to and from this station will not recorded or output to the SMDR for the Mini Call
Accounting feature. When the Mini Call Accounting feature is enabled (see Mode 14-01-08) then all stations which are
used for administration should have this feature disabled to prevent using memory unnecessarily to record their calls.
If calls are allowed to accumulate against stations which are not checked in or out regularly then the system memory
buffer will become full and calls will not be recorded.
IP \ Value 0 1
45-stn-08 Record Do not Record
To Next Page
Loading...