04. Manual Line
If the setting is enabled, lifting the handset of the station will call the operator directly without dialing any digits.
IP \ Value 0 1
44-stn-04 Disabled Enabled
05. Headset Feature
When headset feature is enabled by the user (code is [SPK] [775]) they can then use the [SPK] key to go on or off
hook. If this programming mode is disabled the user cannot switch between handset and headset mode.
IP \ Value 0 1
44-stn-05 Disable Enable
06. Use Engineering Password
If the setting is disable, the station is unable to use the engineering password to enter programming mode.
IP \ Value 0 1
44-stn-06 Disable Enable
07. Reserved
08. Station Alarm Signal
This parameter decides what signal the station will hear when a station alarm or Wake-Up Call is activated.
IP Value Value Description
44-stn-08 0 (set in Mode 05-05-01) default Back Ground Music
44-stn-08 1 Busy tone
To Next Page
Loading...