TransTel Communications G1E+ - Program 05-11-IP: System Timing Parameters - 11; DTMF Caller ID Leading Digit; Number of DISA Passwords; Select Music on Hold or Ring Back Tone

Program 05-11-IP : System Timing Parameters – 11
05-11-IP SYS PAR
0 0 1 0 0 2 5 0
IP =Item Pointer (01-08)
Value for each Item
IP Value Default Item Description
01 0-4 0=None DTMF Caller ID Leading Digit
02 0-1 0=1 DISA Password – 1 / 50 Sets
03 0-2 1=MOH Select Music on Hold or Ring Back Tone
04 0-1 0=0 DISA & ECF Access Delay Time - Night
05 0-3 0=[8],[9],[*],[#] DISA Special Function Access
06 0-9 2=4 Times DISA Re-check Times To Busy Console
07 0-9 5=30 Sec. Door Phone Ringing Time
08 0-8 0=Disable DISA Single Digit Dialing
01. DTMF Caller ID Leading Digit
This parameter defines the start digit of DTMF caller ID signal. The system will omit the start digit for CLI (Caller ID)
data on the display phone and CLI list. Not used in North America.
02. Number of DISA Passwords
This parameter defines the total number of DISA passwords.
At the default setting of 0 the DISA password will be set in mode 13-02. If the parameter is set to 1, there are 50
passwords available to use and they are same as the forced account codes numbers (50-99). Refer to Program: 17
Forced Account Codes.
IP \ Value 0 1
05-11-02 1 Password 50 Passwords
03. Select Music on Hold or Ring Back Tone
This parameter selects what the incoming caller will hear during Ring Transfer and Hold Recall conditions. The feature
is designed to prevent the caller incorrectly recognizing the International Ring Back Tone as a disconnect or busy
signal and hanging up even though their call is still in progress.
IP \ Value 0 1 2
05-11-03 Ring Back Tone Music On Hold Silence
04. DISA & ECF Access Delay Time – Night
This parameter sets the timer that a DISA/ECF (External Call Forwarding) trunk will ring assigned stations (set by
Program 01-tk-IP, 02-tk-IP) prior to being connected to Auto Attendant (DISA) or another Trunk (ECF) in Night mode.
Stations can answer the incoming trunk before it is connected to Auto Attendant or another Trunk.
IP \ Value 0 1 2 3 4 5 6 7 8 9 Unit
05-11-04 0 2 4 6 8 15 30 60 120 254 sec.
Note: 0 = Incoming trunk connects to Auto Attendant or another trunk without ring those assigned stations.
1-9 =Incoming trunk connects to Auto Attendant or another trunk after 2-254 seconds ringing.
Also see Program 05-01-04 for Day and Program 05-17-4 for Lunch delay.