Program 46-stn-IP : Station Class of Service – 4
46-stn-IP STCOS
1 1 2 3 0 7 d 0
stn= Station No. (2-4 digits), IP = Item Pointer (01-08)
Value for each Item
IP Value Default Item Description
01 0-8 1= 1 Dial [87] Trunk Group
02 0-9 0= 1 Send Message Wait Signal Level
03 0-2 0= Auto Answer /MIC Off Automatic Answer Capability / Internal CLIP
04 0-7 3= Recall DISA/ISDN In dial Recall Capability
05 0-9 0= No Limit Maximum Number Of Transfer Times Allowed
06 0-7 7= Yes Door Unlock/DND/CFWD Access
07 0-9, d * 0= d ACP Door Phone Hunt Grp./Permanent C/FW Grp.
08 0-7 0= Normal SLT Ring Cadence Settings
General:
This program permits each station to be assigned to a different Class of Service.
Description:
01. Dial [87] Trunk Group
If this setting is from 1 to 8, after the station dials [87] (or dials [9]), the system will automatically search for a free line
which is assigned in group 1 to 8 in Program Mode 38.
If the setting is 0, then no dial 87 group is available to this station.
Related System Programming Mode: 36, 38, 41-ST-04, 46-ST-01
02. Message Waiting Level
The Stations assigned higher levels can leave message for stations with the same or lower levels. Ten levels (0-9)
are available (9=highest level, 0=lowest level). Stations which are set to 0 can not send a message waiting information
but only receive a message waiting from Stations which are class 9.
IP Value Value Description
46-stn-02 9 Can do Message Waiting to Stations that are assigned level 0-9
46-stn-02 8 Can do Message Waiting to Stations that are assigned level 1-8
46-stn-02 n Can do Message Waiting to Stations that are assigned level 1-n
46-stn-02 1 Only receive Message from Stations whose assigned level is > 2.
46-stn-02 0
Can not do or get Message Waiting from others.(lowest level),
except from stations assigned as level 9.
For Hotel / Lodging applications, it is recommended that you assign a message waiting level so that guest telephones
cannot leave a message for another station in the system. If you set the guest room to 1 then the room phone cannot
leave a message for another station and can ONLY get a message waiting indication from the console operator or the
voice mail system.
Message levels of the same value above 0 can leave messages for one another. Lower message levels cannot leave
messages for higher levels.
Message level 0 is special design for plain phone without Message facility.
To Next Page
Loading...