IP \ Value 0 1 2 3 4 5 6 7 8 9 unit
05-12-04 1 2 3 4 5 6 7 8 9 10 sec.
05. Voice Mail Call Forward Protocol Selection and Muting Leading Digits
This parameter selects between Standard Voice Mail Call Forward Protocol and the Enhanced Protocol. For a full
description of Voice Mail Protocol see Program 05-10.It will also set the muting of the leading digits
Setting Value
0 1 2 3 4 5 6 7
VMS Leading Digit Type
Short Long Short Long Short Long Short Long
Mute Leading Digit
No No Yes Yes No No Yes Yes
Leading Digit for VMS
No Yes No Yes No No Yes No
“Short” type: Use the Leading Digit programmed in program 05-10.
“Long” type: Use 10 Leading Digits. Refer to Mode 05-10 (Enhanced Protocol)
“Mute Leading Digit”: The caller will not hear the DTMF signal during the transmission of leading digits.
“ Leading Digits for VMS”:
Yes: When incoming caller call the voice mail directly, the system will send the Leading digits
(7+ CO trunk number)
No: When incoming caller call the voice mail directly, the system will not send any leading digits.
Note: Refer to Mode 05-10 for the leading digits as follow:
Voice Mail System Leading Digit Format (TCI version only)
1+ extension number = CFWD All Calls (Replaces 11 and 21eeeexxxx)
2+ extension number = CFWD Busy (Replaces 12 and 22eeeexxxx)
3+ extension number = CFWD No Answer (Replaces 13 and 23eeeexxxx)
4+ extension number = Direct Call to Voice Mail (Station) (Replaces 14eeeexxxx)
5+ extension number = Call Record (Replaces 15eeeexxxx)
6+ extension number = Recall to Voice Mail (Replaces 25eeeexxxx)
7+ CO trunk number = Incoming CO Call (Replaces 2400tt00tt)
Related System Programming Mode: 05-10, 43-cn-03, 50-ST-05
06. Linear / Circular Trunk Group Access
If this parameter is set to 0 then line selection will be the first available trunk in the users dial (9-0) group. If the
parameter is set to 1 then the lines will be selected in a Circular fashion till all lines have been used and then the
selection will start again. Do NOT use Circular with PSTN lines unless there is a very good reason as call collision will
result. Trunk Groups are programmed in Mode 36-gp.
IP \ Value 0 1
05-12-06 Linear Circular
To Next Page
Loading...