Program 05-20-IP : System Timing Parameters – 20
05-20-IP SYS PAR
0 0 0 0 0 0 0 0
IP = Item Pointer (01-08)
Value for each Item
IP Value Default Item Description
01 0-1 0= Disable VMU Mailbox Delete All Messages (g1-A52x)
02 0-6 0= DISA No Digits Dialed Destination (g1-A52yb5)
03 0- 0= Reserved
04 0-9 0=Disable VMU Silence Detection
05 0- 0=Australia Distinctive Ring Selection Australia or New Zealand
06 0- 0= Reserved
07 0- 0= Reserved
08 0- 0= Reserved
01. VMU Mailbox Delete All Messages
This option enables or disables a message within the G1E+ VMU that prompts a user to delete all messages within
their own mailbox. When enabled, during a mailbox’s main menu, the optional prompt “Press 5 to delete all
messages,” will be played. Pressing the digit 5 will clear all message, new and old that are present in the mailbox. If
disabled, this prompt will not be played. U.S. Voice prompt version for the G1E+ VMU must be 5116 or higher. Older
versions do not have the prompt in the prompt library.
02. DISA No Digits Dialed (End of Message) Destination
This parameter controls how calls are handled if the caller dials no digits at the DISA main greeting.
A setting of 0 will cause the VMU to either disconnect the caller or transfer the caller to the appropriate operator as
programmed on 05-07-04.
A setting of 1 through 6 will route the caller to one of the six virtual mailboxes in the system, so that the caller can
leave a message.
1= Virtual mailbox 41 2= Virtual mailbox 42
3= Virtual mailbox 43 4= Virtual mailbox 44
5= Virtual mailbox 45 6= Virtual mailbox 46
03. Reserved
04. Reserved
05. Reserved
06. Reserved
07. Reserved
08. Reserved
To Next Page
Loading...