TransTel Communications G1E+ - ACP Door Phone Hunt Group; Permanent Call Forward Group - no Answer; SLT Ring Cadence Settings

07. ACP Door Phone Hunt Group / Permanent Call Forward Group – No Answer
IP \ Value 0 1 2 n 9 d *
46-st-07 Group 1 Group 2 Group 3 Group n+1 10 Program 3 VMC
This parameter allocates the Station Hunt Group that the ACP will call if it is programmed as a Door Phone and the
Call button is pressed. When setting is d; the ACP will call the extension according to the assignment in Program 3:
Door Phone Ring Assignment
If the Extension is not an ACP then this parameter sets the Permanent Call Forward destination Hunt Group on No
Answer. If the Station user sets a Call Forward manually then it will override this setting but after cancelling the manual
Call forward then this setting will be enabled again.
An entry of * will set permanent Call Forward No Answer to the internal Voice Mail Card. This option should be used
when forwarding to the voice mail is desired but calls are not answered by Automated Attendant (DISA).
See also Mode 78-st-04: Call Forward Group - Busy.
08. SLT Ring Cadence Settings
If the Station is an SLT then this parameter will set the ring Cadence for calls as follows.
IP \ Value 0 1 2 3 4
46-stn-05 Normal Always Trunk ring pattern Always Intercom ring pattern Special Ring Fax Ring