Program 38-gp-tk : Dial 87 Trunk Group Assignments
38-gp-IP TK GRP
01 02 03 04 05
gp = Group (01-08), IP = Item Pointer (01-12)
Trunks to be included
General:
This program permits each trunk line to be assigned to different Trunk groups which can be accessed by dialing [87].
There are 8 groups in total. This group will be available to a station in addition to or instead of it's dial 9 group. Always
set outgoing calls to start from the highest installed trunk and program in descending order to the lowest installed
trunk. This will prevent call collision particularly in systems with SLT'S. Press [REDIAL] to clear all entries in the table
before entering required trunks.
Description:
This program is different from Program Mode 36-gp-tk. This program is used for dialing [87] or [9] to access a Trunk
Line.
Once a dial [87] group has been programmed it will need to be assigned to the stations that are to use it in
Mode 46-Stn-01.
Related System Programming Mode: 36, 38, 41-ST-04, 46-ST-01
To Next Page
Loading...