TransTel Communications G1E+ - Program 05-07-IP: System Timing Parameters - 07; Intercom Searching; Toll Override Prevention from Quick Dial; Paging Alert Tone

Program 05-07-IP : System Timing Parameters – 07
05-07-IP SYS PAR
0 0 0 0 0 0 0 0
IP = Item Pointer (01-08)
Value for each Item
IP Value Default Item Description
01 0-1 0=Disable Intercom Searching
02 0-1 0=Disable Toll Override Prevention from Quick Dial
03 0-1 0=Enable Paging Alert Tone
04 0-7 0=Enable DISA Transfer To Console - No Dialing
05 0-1 0=Disable Key Phone Toll Override Prevention
06 0-9 0=Disable SMDR Digit Mask
07 0-9 0=0 sec. Guard Time for CO Line Re-accessing
08 0- 0= Reserved
01. Intercom Searching
If Enabled, when calling an internal station which is busy or does not answer, pressing [4] will call the next station
which is in the same station group as the called station. If setting is Disabled, then there will be no such searching.
IP \ Value 0 1 2 3
05-07-01 Disabled Enable when busy Enable when no answer Enable when busy or no answer
02. Toll Override Prevention from Quick Dial
To protect toll override control when a Key phone selects a trunk and quickly dials one digit to bypass the toll control.
When this parameter is set to Enabled, after selecting a trunk, the first digit dialed will be delayed one pause interval to
send to the Central Office.
IP \ Value 0 1
05-07-02 Disable Enable
03. Paging Alert Tone
This parameter enables/disables the paging alert tone.
IP \ Value 0 1
05-07-03 Enable page alert tone Disable page alert tone
04. DISA Recall To Console - No Dialing
If this function is activated, when a DISA call is answered but the caller does not dial any digits or station number, the
system will recall the Operator after the assigned DISA Transfer Time No Dialing (Program 05-08-07). If this function
is disabled the call will be disconnected after Transfer Time No Dialing elapses. This parameter is also used to clear
the VMU channels after 10 minutes of operation where central offices do not provide proper disconnect supervision
(CPC/CFS signal).
IP \ Value 0 1 2 3
05-07-04
Recall to
operator
No Recall to
operator
Recall to operator and
release line after 10
min.
No Recall to operator
and release line after 10
min.