turck FGEN-AIM Series - Name Assignment for FGEN-Stations

D301271 1013 - FGEN - multi protocol
12-11
Application example
12.1.8 Name assignment for FGEN-stations
Now, the node’s IP configuration or device name can be adapted, if necessary for the application.
In this example, the following properties are assigned to the modules:
 FGEN-IOM88-x001
– Device name: TURCK-FGEN-90
 FGEN-XSG16-x001
– Device name: TURCK-FGEN-107
Figure 12-13:
Adaptation of
the Ethernet
node configura-
tion
o
Note
Here, you can also assign an application specific device name to the devices which were
found.
Please observe, that the device name assigned here has to be similar to the device name
assigned to the node in the properties dialog box (see Figure 12-11: Dialog: properties turck-
fgen).
If this is not guaranteed, the PLC will not be able to clearly identify the node!