turck FGEN-AIM Series - Setting the Ethernet-Ports (Port 1 and Port 2)

D301271 1013 - FGEN - multi protocol
12-17
Application example
Setting the Ethernet-Ports (Port 1 and Port 2)
In order to enable a faster startup of devices, the Ethernet ports of the respective devices have to be
configured as follows:
 Autonegotiation: disable
 Transmission medium / duplex: set to a fixed value
Here also, the port configuration is shown using the example of port 1 at station turck-fgen-107.
Note
Please observe, during configuration, that the settings for the ports of neighboring devices
are identical.
Figure 12-19:
Configuring one
Ethernet-port
Note
This configuration has to be set for the neighbor-port of the neighboring node turck-fgen-
90 as well.