turck FGEN-AIM Series - Parameters

D301271 1013 - FGEN - multi protocol
6-7
FGEN-XSG16-000x
6.2.3 Parameters
Further information about the parameter data mapping can be found in the fieldbus specific chapters.
 EtherNet/IP™: chapter 7.3.3, Process data mapping FGEN-XSG16-x001 (page 7-17) ff.
 Modbus TCP: chapter 9.3.2, Register mapping of the FGEN-stations (page 9-11) ff.
 PROFINET: chapter 11.4, Parameters (page 11-5)
Table 6-5:
Parameters
Parameter name Value Description
A default
setting
Digital input
(Inv. DI)
0 = normal A
1 = inverted Inverts the digital input signal.
Output on
overcurrent
(SROx)
0 = activated
A The output switches on automatically after an overload.
1 = deactivated The output is manually switched-off after an overload.until
a new set-command is given (rise and fall).
output 0 = deactivated
1 = activated
A