turck FGEN-AIM Series - Parameters; Diagnostic Messages

D301271 1013 - FGEN - multi protocol
5-3
FGEN-OM16-x001
5.1.3 Parameters
Further information about the parameters can be found in the fieldbus specific chapters.
 EtherNet/IP™: chapter 7.4.4, Digital Versatile Module Class (VSC117) (page 7-34) ff.
 Modbus TCP: chapter 9.3.2, Register mapping of the FGEN-stations (page 9-11) ff.
 PROFINET: chapter 11.4, Parameters (page 11-5)
5.1.4 Diagnostic messages
Further information about the diagnostic data mapping can be found in the fieldbus specific chapters.
 EtherNet/IP™: chapter 7.4.3, Process Data Class (VSC102) (page 7-31) ff.
 Modbus TCP: chapter 9.3.2, Register mapping of the FGEN-stations (page 9-11) ff.
 PROFINET: chapter 11.3, PROFINET-Error Codes (page 11-4)
Table 5-2:
Parameters
Parameter name Value Description
A default
setting
Output on
overcurrent
(SROx)
0 = activated A The output switches on automatically after an overload.
1 = deactivated The output is switched-off after an overload until a new set-
command is given (fall and rise).
Table 5-3:
Diagnostic
messages
Diagnostics Description
SCOx Short circuit at output of the respective channel