turck FGEN-AIM Series - Configuration of the Network in RS Logix 5000; Configuration of the Controller; Network Configuration

D301271 1013 - FGEN - multi protocol
8-3
Network configuration
8.2 Network configuration
The FGEN-stations are delivered with the IP address 192.168.1.1.
To achieve this, you have either
 to adjust the FGEN‘s IP address via BootP, DHCP etc. for integrating it into your own network (for
detailed information about the different possibilities for address setting, please read chapter 3,
Connection possibilities, page 3-6.
or
 to change the IP address of the used PC or network interface card (for detailed information, please
read the Changing the IP address of a PC/ network interface card (page 14-2).
8.2.1 Configuration of the network in "RS Logix 5000"
The EtherNet/IP™ hosts (PLC, EtherNet/IP™ interface, I/O stations) have to be configured using the
software "RS Logix 5000" (in this example version 15) from Rockwell Automation.
Start RS Logix and open a new project using the "File" menu.
Configuration of the controller
Enter the information related to the controller depending on your configuration, as well as a name for
the project.
Note
In order to build up the communication between the FGEN-station and a PLC/ PC or a network
interface card, both devices have to be hosts in the same network.
Figure 8-1:
Creating a new
project in RS
Logix
Figure 8-2:
Configuration
of the controller