Application example: FGEN for PROFINET with a Siemens S7
D301271 1013 - FGEN - multi protocol12-16
12.1.11 Fast Start-Up - configuration of fieldbus nodes
In the following example, the FGEN-stations from the application example will be configured for FSU-
operation:
station 1: turck-fgen-107
station 2: turck-fgen-90
Prioritized stat-up - activation at PN-IO
FSU is activated at the PN-IO slots of FSU- devices in the hardware configuration (HW Config) in the
Simatic software:
In this example, the PN-IO-slots of the two FGEN-stations are configured respectively.
The following figure shows the activation of the prioritized start-up using the example of the node
turck-fgen-107:
Figure 12-18:
Prioritized start-
up, settings at
the PN-IO-slot
Note
This configuration has to be set for node turck-fgen-90 as well.
To Next Page
Loading...
