turck FGEN-AIM Series - Dimensions for the FGEN-Stations

D301271 1013 - FGEN - multi protocol
8-5
Network configuration
Dimensions for the FGEN-stations
1 Add the stations to the I/O configuration by using a right-click on the EtherNet/IP™ bridge module
1756-ENBT/A and select "New Module".
2 Open "Communications" and select the entry "Generic Ethernet Module" to configure the station.
3 Enter the necessary device information, like "Module name" and "Communication format" and
define the station‘s IP-address and the connection parameters.
Figure 8-6:
Adding an FGEN
to the I/O
configuration
Figure 8-7:
Add generic
Ethernet
module