D301271 1013 - FGEN - multi protocol
8-1
8 Application example: FGEN for EtherNet/IP™ with Allen Bradley PLC and
RS Logix 5000
8.1 General........................................................................................................................................................8-2
8.1.1 Used hard-/ software ......................................................................................................................................................................8-2
– Hardware.........................................................................................................................................................................................8-2
– Software...........................................................................................................................................................................................8-2
8.2 Network configuration .............................................................................................................................. 8-3
8.2.1 Configuration of the network in "RS Logix 5000".................................................................................................................8-3
– Configuration of the controller...............................................................................................................................................8-3
– Dimensions for the FGEN-stations.........................................................................................................................................8-5
8.2.2 Downloading the I/O configuration..........................................................................................................................................8-8
8.3 I/O data mapping .....................................................................................................................................8-10
8.4 Process data access ..................................................................................................................................8-11
8.4.1 Setting outputs .............................................................................................................................................................................. 8-11
8.4.2 Example program.......................................................................................................................................................................... 8-11
8.5 Activating QuickConnect........................................................................................................................8-13