turck FGEN-AIM Series - Gateway Class (VSC 100); Class Instance; Object Instance 1

D301271 1013 - FGEN - multi protocol
7-29
VSC-Vendor Specific Classes
7.4.2 Gateway Class (VSC 100)
This class contains all information which refers to the whole station not to the different
I/O channels.
Class instance
Object Instance 1
Note
Please refer to paragraph Class instance of the VSC (page 7-28) for the description of the class
instance for the VSC.
Table 7-23:
Object instance 1,
Boot instance
Attr. No.
dec.
(hex.)
Attribute name Get/
Set
Type Description
100
(64h)
Max object
attribute
GUSINT Contains the number of the last object
attribute to be implemented.
101
(65h)
Hardware revision GSTRUCT Contains the hardware revision number of the
station (USINT Maj./USINT Min.)
102
(66h)
Firmware revision GSTRUCT Contains the revision number of the Boot
Firmware (Maj./Min.).
103
(67h)
Service tool ident
number
GUDINT Contains the BOOT ID number that serves as
an identification number for the software I/O-
ASSISTANT
104
(68h)
Hardware
info
GSTRUCT Contains station hardware information (UINT):
– count (number of the following entries)
–CLOCK FREQUENCY (kHz)
–MAIN FLASH (in kB)
– MAIN FLASH SPEED (ns)
–SECOND FLASH (kB)
–RAM (kB),
– RAM SPEED (ns),
– RAM data WIDTH (bit),
– SERIAL EEPRPOM (kbit)
– RTC SUPPORT (in #)
– AUTO SERVICE BSL SUPPORT (BOOL)
–HDW SYSTEM