Application example: FGEN for EtherNet/IP™ with Allen Bradley PLC and RS Logix 5000
D301271 1013 - FGEN - multi protocol8-4
Your project will be opened offline. In order to configure the network, please right-click "I/O
Configuration" and select "new Module" to add the first host, the EtherNet/IP™ bridge, to the network.
Open "Communications" and select the bridge. In this example this would be 1756-ENBT/A.
Enter the "Major Revision" of your EtherNet/IP™ bridge and click "OK".
In the following dialog box "New Module" enter a name for the bridge and define its IP Address (in this
example 192.168.1.100).
In the following dialog box "Module Properties: Local..." press "OK".
The configuration of the interface is completed.
Press "Finish" to close the dialog box
Figure 8-3:
Configuration
of the EtherNet/
IP™ Bridge
Figure 8-4:
Major Revision
of the EtherNet/
IP™ Bridge
Figure 8-5:
Configuration
of the EtherNet/
IP™ Bridge
To Next Page
Loading...
