Connecting a GPS receiver
To determine whether the information on this page applies to your
scanner, see the tags at the bottom of the page.
● Compatible GPS receivers
● Configuring your scanner
● Connecting the receiver
● Troubleshooting
Compatible GPS receivers
You can connect your scanner to any GPS receiver that meets the following criteria:
● Outputs NMEA-0183 v3.01-compliant location data
● Outputs both the Global Positioning System Fix ( GGA ) and Recommended
Minimum Specific GNSS ( RMC ) data sentences
● Provides a serial data (RS-232) connection
Configuring your scanner
1. Go to the Settings menu and select Set Serial Port .
2. Select Set Baud Rate.
3. Select Set Rear Port.
4. Select 4800 bps for the baud rate.
Connecting the receiver
file:///C|/Documents%20and%20Settings/POpitz/My%20D...age_090515/Manual/MobileConnectingAGPSReceiver.html (1 of 3)5/26/2009 11:12:33 AM
To Next Page
Loading...
