■ Channel properties
Programming an LTR System
To program an LTR system, you'll need to program the required elements in following order (click here
for information on using the menu):
Create a system
1. Go to the Program System menu and choose New System .
2. The scanner will prompt you for the System Type. Select LT .
3. When the scanner prompts you confirm, tap YES .
4. The scanner creates the system with a default name. Select Edit Name if you want to change it.
5. If you need to change any of the system properties, you can do that now. Unless a property is
Required , you can operate the system without changing the default settings.
System properties
All of these options can be found under your scanner's Program System menu. If necessary, the sub-
menu and option name on each scanner are listed beside the property.
Property Option name
Required
None
Recommended
Name
Edit Name
Number tag
Set Number Tag
Optional
Automatic Gain Control
(AGC)
BCD396XT and BCD996XT: Set Audio
AGC
BC346XT and BCT15X: Not available
Record Out
BCD996XT and BCT15X: Set Record
BCD396XT and BC346XT: Not available
file:///C|/Documents%20and%20Settings/POpitz/My%20D...s/temp/CDImage_090515/Manual/LTRTrunkedSystems.html (2 of 7)5/26/2009 11:11:52 AM
To Next Page
Loading...
