Uniden BCD396XT - Page 369

Thursday, May 14, 2009
120
Location Based Scanning
This operation controls the lockout state for each group or site when the scanner is connected to a GPS
unit.
This works automatically based on the location data from GPS when the feature is set to “On” in Set GPS
Enable.
If the scanner goes within the location’s range for a group or site, the scanner displays "Location Unlock"
on the first line and the group name or the site name on second line.
GPS
Locati on Unlock
Si te 1- 1 MOT
S0: - - - - - - - - - -
GRP - - - - - - - - - -
When the scanner goes outside the set range, the group or site is automatically temporarily locked out.
The scanner displays “Location L/O” on first line and the group name or the site name on second line.
GPS
Locati on L/O
Si te 1- 1 MOT
S0: - - - - - - - - - -
GRP - - - - - - - - - -
This operation does not affect systems/sites whose SQK is disabled.
If a GPS is detected as soon as the scanner is turned on, the scanner displays "GPS CONNECTED" instead of
displaying individual lock/unlock messages for groups and sites. It applies the location-based rules to all
systems at one time.
GPS
GPS CONNECTED
S0: - - - - - - - - - -
GRP - - - - - - - - - -