Uniden BCD396XT - Page 542

BandScopeMode < UnidenMan4 < TWiki
This page applies only to the BCD396XT and BC346XT. For other models
see:
● BCT15X Band Scope Mode
● BCD996XT Band Scope Mode
Band Scope mode
Band Scope mode is a special type of Search mode where the scanner displays the strength
of any signal it finds.
● In a band scope search, the scanner starts at the lowest frequency in the range and
moves up the search range.
● In Max Hold Search mode, the scanner displays the strongest signal that it found.
● If you manually set the mode to NFM or FM, the scanner will not reliably detect
signals that are modulated in either FMB or WFM.
To turn on Band Scope mode:
Band Scope mode is the default setting for Search Key 3. To turn on Band Scope mode,
enter Search mode, then tap FUNCTION + 3 (SR3) . (To change the Search Key
assignment, see
Search Keys#Programming Search Keys.)
Reading the display in Band Scope mode
file:///C|/Documents%20and%20Settings/POpitz/My%20D...ments/temp/CDImage_090515/Manual/BandScopeMode.html (1 of 4)5/26/2009 11:13:58 AM