Uniden BCD396XT User Manual

BCT15XHoldMode < UnidenMan4 < TWiki
FUNCTION +
Tap
Toggle the Weather
Priority mode.
Toggle the attenuator state. NA Change the modulation.
FUNCTION +
Press & hold
Go to Weather Scan
mode.
Toggle the attenuator state for all
signals.
If on a channel that has a
valid reverse (input)
frequency, show the repeater
reverse frequency for the
current frequency (the
scanner returns to the
original frequency when you
release the key).
NA
Key Name
(2nd operation)
Action on:
Menu
. / No (Decimal) 0 Yes (Enter)
Tap Enter the Menu Mode.
If you've entered a
system number tag/
channel number tag in
Direct Entry, go to the
specified system and
channel.
Enter a decimal point, hyphen, or
"i" for Direct Entry.
Enter 0 in Direct Entry. Go to edit mode for the
current channel or, if set to a
trunked system frequency go
go the edit mode for the
system.
FUNCTION +
Tap
Enter the Menu for the
current system or search
range.
NA NA NA
Key Name
(2nd operation)
Action on:
SQUELCH
VOLUME
SCAN/SEARCH
HOLD/RESUME
Rotate Adjust Squelch. Adjust volume. Turn fully
counterclockwise past click to
turn off scanner.
NA NA
Tap Stop an alert tone and
temporarily mute alerts.
Tap again to unmute.
Change backlight level. Resume scanning. Resume scanning.
Press & Hold Permanently mute alerts.
Tap to unmute.
NA NA Hold on the current system
and resume scanning.
FUNCTION +
Tap
Toggle Close Call
modes.
Select the state for state-by-state
search modes.
Go to the Quick Search
prompt.
Resume Scanning.
FUNCTION +
Press and Hold
Start Close Call Only
mode.
NA NA Hold on the current system
and resume scanning.
file:///C|/Documents%20and%20Settings/POpitz/My%20...nts/temp/CDImage_090515/Manual/BCT15XHoldMode.html (2 of 6)5/26/2009 11:16:17 AM

Uniden BCD396XT Specifications

General

Belt clip	Yes

Weight and Dimensions

Weight	907 g
Dimensions (WxDxH)	51 x 25 x 1152 mm