Unify OpenStage 40 SIP

Enhanced phone functions 103
Allowing "Busy When Dialling"
If you activate this function, an incoming call received while you are performing
dialling is rejected. The caller then hears the busy signal.
z
You can also configure this setting via the WBM interface  Page 206.
N Press the key shown.
Select and confirm the option shown.
Select and confirm the option shown.
if nec.j Enter and confirm the User password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown in the context menu.
Select and confirm the option shown.
Settings
User
Configuration
Outgoing calls
Busy when dialling
Yes
Save & Exit
This setup option can also be found under "Handling" in the "Incoming
calls" menu.