Unify OpenStage 40 SIP

Individual phone configuration 187
Key click
You can configure whether a key click should be audible when a key is pressed.
You can also decide whether this should apply for all keys or only for the keys
on the keypad. In addition, you can adjust the click volume or disable the sound.
z
You can also configure this setting via the WBM interface  Page 206.
N Press the key shown.
Select and confirm the option shown.
Select and confirm the option shown.
if nec. j Enter and confirm the User password.
Select and confirm the option shown.
Select and confirm the option shown.
Adjusting the volume for the Key click
Select and confirm the option shown.
For instance, select and confirm a medium volume level. You can also select one
of the following three options:
•Low
• High
• Off (for no click)
Key selection
Select and confirm the option shown.
Select and confirm if the setting is only to apply for the character input keys.
or
Select and confirm the option shown.
Confirm the option shown.
Settings
User
Phone
Key click
Volume
Medium
Keys
Keypad only
All keys
Save & Exit